Chapter 48 Port Status
XGS1930 Series User’s Guide
337
Figure 244 Port Status > Port Details
The following table describes the labels in this screen.
Table 175 Port Status: Port Details
LABEL DESCRIPTION
Port Info
Port NO. This field displays the port number you are viewing. In stacking mode, the first number represents
the slot and the second the port number.
Name This field displays the name of the port.
Link This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps, 1000M for 1000Mbps, or
10G for 10 Gbps) and the duplex (F for full duplex or H for half duplex). It also shows the cable type
(Copper or Fiber) for the combo ports. This field displays Down if the port is not connected to any
device.
State If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port. See page 131
for more information.
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it displays STOP.
When LACP (Link Aggregation Control Protocol), STP, and dot1x are in blocking state, it displays
Blocking.
LACP This field shows if LACP is enabled on this port or not.
TxPkts This field shows the number of transmitted frames on this port
To Next Page
Loading...
