Chapter 4 The Web Configurator
XGS1930 Series User’s Guide
37
Figure 22 Web Configurator: Login
4 Click Login to view the first web configurator screen.
Click the Visit button to open the Zyxel Nebula Control Center (NCC) login page in a new tab or
window. The NCC is a cloud-based network management system that allows you to remotely manage
and monitor the Switch in Nebula cloud management mode (see Section 1.1.1 on page 18).
5 The Wizard screen will appear after logging into the Switch. You can use the Wizard screen to configure
the Switch’s IP, login password, SNMP community, link aggregation, and so on. See Section 4.3 on page
40 for more information on the Wizard screen. When you finish configuring the settings, you can click the
Apply button to make the settings take effect. Check the screens to see if the settings are applied, and
click the Save button in the top to save your configuration into the Switch’s nonvolatile memory. You
can also just click the Apply & Save button to make the settings takes effect, and save your
configuration into the Switch’s nonvolatile memory at once.
Note: Once you click the Apply or Apply & Save button, the settings configured in the Wizard
screen will overwrite the existing settings.
Otherwise, click the Exit button. You can select the Ignore this wizard next time check box if you don’t
want the Wizard screen to appear the next time you log in. If you want to open the Wizard screen later,
click the Wizard icon in the upper right hand corner of the web configurator.
To Next Page
Loading...
