3B6 COBO View Tech HC115 - Page 31

Calibration Procedure
s
I
31
“Move A1 at 80” : move the boom until the angle 80 degree;
”ENTER TO START” : press key to continue.
If the system allow the action, the system will go immediately to the next step.
Note important:
If your machine doesn’t reach 80 degree, press enter to skip.
Move A1 at 80
ENTER TO START
”Move A1 at 75” : move the boom until the angle 75 degree;
”ENTER TO START” : press key to continue.
If the system allow the action, the system will go immediately to the next step.
Note important:
If your machine doesn’t reach 75 degree, press enter to skip.
Move A1 at 75
ENTER TO START
”Move A1 at 70” : move the boom until the angle 70 degree;
”ENTER TO START” : press key to continue.
If the system allow the action, the system will go immediately to the next step.
Note important:
If your machine doesn’t reach 70 degree, press enter to skip.
Move A1 at 70
ENTER TO START
”Move A1 at 65” : move the boom until the angle 65 degree;
”ENTER TO START” : press key to continue.
If the system allow the action, the system will go immediately to the next step.
Note important:
If your machine doesn’t reach 65 degree, press enter to skip.
Move A1 at 65
ENTER TO START
”Move A1 at 60” : move the boom until the angle 60 degree;
”ENTER TO START” : press key to continue.
If the system allow the action, the system will go immediately to the next step.
Move A1 at 60
ENTER TO START
”Move A1 at 55” : move the boom until the angle 55 degree;
”ENTER TO START” : press key to continue.
If the system allow the action, the system will go immediately to the next step.
Move A1 at 55
ENTER TO START
”Move A1 at 50” : move the boom until the angle 50 degree;
”ENTER TO START” : press key to continue.
If the system allow the action, the system will go immediately to the next step.
Move A1 at 50
ENTER TO START