3B6 COBO View Tech HC115 - Page 32

32
I CLS
-
LMI
-
Calibration
I
ENGLISH
“Move A1 at 45” : move the boom until the angle 45 degree;
”ENTER TO START”: press key to continue.
If the system allow the action, the system will go immediately to the next step.
Move A1 at 45
ENTER TO START
”Move A1 at 40” : move the boom until the angle 40 degree;
”ENTER TO START” : press key to continue.
If the system allow the action, the system will go immediately to the next step.
Move A1 at 40
ENTER TO START
“Move A1 at 35” : move the boom until the angle 35 degree;
”ENTER TO START”: press key to continue.
If the system allow the action, the system will go immediately to the next step.
Move A1 at 35
ENTER TO START
”Move A1 at 30” : move the boom until the angle 30 degree;
”ENTER TO START” : press key to continue.
If the system allow the action, the system will go immediately to the next step.
Move A1 at 30
ENTER TO START
“Move A1 at 25” : move the boom until the angle 25 degree;
”ENTER TO START”: press key to continue.
If the system allow the action, the system will go immediately to the next step.
Move A1 at 25
ENTER TO START
“Move A1 at 20” : move the boom until the angle 20 degree;
”ENTER TO START”: press key to continue.
If the system allow the action, the system will go immediately to the next step.
Move A1 at 20
ENTER TO START
“Move A1 at 15” : move the boom until the angle 15 degree;
”ENTER TO START”: press key to continue.
If the system allow the action, the system will go immediately to the next step.
Move A1 at 15
ENTER TO START
”Move A1 at 10” : move the boom until the angle 10 degree;
”ENTER TO START” : press key to continue.
If the system allow the action, the system will go immediately to the next step.
Move A1 at 10
ENTER TO START