This step is required every time you want to change the value of the radius
when the boom is load during the calibration.
WEIGHT CALIB 0
Rad Load .0
Press and insert the value of the radius;
By key move asterisk and by or change the value.
When you finish press
*
Rad Load .0
Unload Radius:
This step is required every time you want to change the value of the radius
when the boom is unload during the calibration.
WEIGHT CALIB 0
Rad UnLoad .0
Press and insert the value of the radius;
By key move asterisk and by or change the value.
When you finish press
*
Rad UnLoad .0
Memo Hook:
This step is required every time you want to begin a hook calibration (UnLoad).
During this Operation on the first Line you’ll can see 100. This mean that the
system is working. When this value will become 0, the operation will finish.
WEIGHT CALIB 100
Memo Hook
Memo Lift Load:
This step is required every time you want to begin a calibration with a lift Load.
During this Operation on the first Line you’ll can see 200. This mean that the
system is working. When this value will become 0, the operation will finish.
WEIGHT CALIB 200
Memo Hook
In general calibration is the same for all cranes; the only thing that change is the number of the length that you have to
correct (max 10).
To Next Page
Loading...
