3B6 COBO View Tech HC115 - Page 45

Alarm Codes
I
45
6 Calculation value of the
boom length sensor 1 lower
than the minimum threshold
•
••
• Verify that the cable or the connector wiring is
not broken
If the alarm persists, please, contact Technical Assistance :
•
••
• Verify the length transducer integrity
7 Calculation value of the
boom length sensor 1 higher
than the maximum threshold
•
••
• Verify that the cable or the connector wiring are
not in short circuit
If the alarm persists, please, contact Technical Assistance :
•
••
• Verify the pressure transducer integrity.
8 Analogical value of pressure
transducer (bottom side n.1)
lower than the minimum
threshold
•
••
• Verify that the cable or the connector wiring are
not damaged
If the alarm persists, please, contact Technical Assistance :
•
••
• Verify the pressure transducer integrity.
9 Analogical value of pressure
transducer (bottom side n.1)
higher than the maximum
threshold
•
••
• Verify that the cable or the connector wiring are
not in short circuit
If the alarm persists, please, contact Technical Assistance :
•
••
• Verify the pressure transducer integrity.
10 Analogical value of pressure
transducer (rod side) lower
than the minimum threshold
•
••
• Verify that the cable or the connector wiring are
not damaged
If the alarm persists, please, contact Technical Assistance :
•
••
• Verify the pressure transducer integrity.
11 Analogical value of pressure
transducer (rod side) higher
than the maximum threshold
•
••
• Verify that the cable or the connector wiring are
not in short circuit
If the alarm persists, please, contact Technical Assistance :
•
••
• Verify the pressure transducer integrity.
12 Analogical value of pressure
transducer (bottom side n.2,
if present) lower than the
minimum threshold
•
••
• Verify that the cable or the connector wiring are
not damaged
If the alarm persists, please, contact Technical Assistance :
•
••
• Verify the pressure transducer integrity.
13 Analogical value of pressure
transducer (bottom side n.2,
if present) higher than the
maximum threshold
•
••
• Verify that the cable or the connector wiring are
not in short circuit
If the alarm persists, please, contact Technical Assistance :
•
••
• Verify the pressure transducer integrity.