3B6 COBO View Tech HC115 - Page 46

46
I CLS
-
LMI
-
Calibration
I
ENGLISH
14 Internal alarm of
Angle/boom-length sensor
ACT
•
••
• Contact Technical Assistance
18
Internal error CAN-BUS ACT
•
••
• Verify the Angle/Boom-length sensor integrity
•
••
• Verify the connecting cable integrity
If the alarm persists, please, contact Technical Assistance
30
Congruency Alarm of the
system’s output
•
••
• Reboot your system
•
••
• Contact Technical Assistance
31
Overload 110%
•
••
• Release the lifting load
•
••
• Perform safety operation for having higher lifting
duty
32
Overload 115%
•
••
• Release the lifting load
•
••
• Perform safety operation for having higher lifting
duty
33
Overload 120%
•
••
• Release the lifting load
•
••
• Perform safety operation for having higher lifting
duty
40 CRC Error of program
•
••
• Contact Technical Assistance
41 CRC Error of load charts
•
••
• Contact Technical Assistance
42 CRC Error of program
execution
•
••
• Contact Technical Assistance
50 LMI By-pass key is activated Pay attention to machine operation.