7
7 Options
7.1 [30 Parameters] Parameters Visualization And Modification
This section shows and let you modify machine parameters following entering data procedures as seen in par. 3.7
7.2 [53 Init Black Box] Black Box Initialisation
PROCEDURES STATUS
IN THE CONTROL AREA
Follow steps in 3.5 paragraph to select and enter the menu parameters
Pressing the
keys, seek the page as shown on the right.
Press to get in.
A 68 L 8.1 W 1.2
53 CALIBRATION
This function is necessary when you have to reset all the alarms.
Press ,and on the display will appear the sign “esc to confirm”, then press
the key
OPTIONS
Esc to Confirm
To Next Page
Loading...
