106 CHAPTER 7: TROUBLESHOOTING FOR WINDOWS 3.X
Starting the Group 3 Test
Follow these steps to run the Group 3 test on the
3C509B NIC:
1 Start the Configuration and Diagnostics Program on
the PC in which the NIC to be tested is installed.
2 From the Test menu, select Test Setup.
3 Enable the Group 3 test. Select OK and press Enter.
4 Go to the Run Tests dialog box to start the tests.
5 After the test is completed:
a Exit the program on the echo server.
b Exit the Configuration and Diagnostics Program.
Getting Help If a Test Fails
If a diagnostic test fails, the NIC may not be defective. The
problem may be incorrect configuration settings, settings
that conflict with other NICs, or improper installation.
For more information about a failed diagnostic test:
■ Select the test that failed in the Run Tests dialog box
and press Enter.
■ Select the Zoom button and press Enter.
CAUTION: If you intend to remove the NIC from your PC,
make sure to turn the power off before removing or
reinserting the NIC.
Book Page 106 Monday, June 7, 1999 8:55 AM
To Next Page
Loading...
