Windows 95/98 Setup 31
■ If your PC does not support the Windows 95/98 Plug
and Play feature, the screen shown in Figure 8 appears.
Click OK and go to “Disabling Plug and Play on the NIC”
on page 41.
Figure 8 Non-Plug and Play BIOS Detected Screen
To install the NIC using the 3Com Installation Wizard
Express installation option, see the Quick Guide for the
EtherLink 10 Mbps ISA Network Interface Card that
shipped with the 3C509B NIC. To set up the NIC for
installation using the 3Com Installation Wizard Custom
installation option, go to the next section.
NIC Configuration in a Windows 95/98 Plug and Play PC
This section describes how to set up your system environment
when installing the NIC in a Windows 95/98 PC that has a
Plug and Play BIOS installed.
Configuring the NIC for Windows 95, Version 950
Follow these steps to configure the NIC in a PC that has a
Plug and Play BIOS installed, and that is running Windows 95
version 950 (also known as version 950a, version A, or the
“retail” version):
1 Turn the power on and boot Windows 95.
The New Hardware Found screen appears, as shown
in Figure 9.
Book Page 31 Monday, June 7, 1999 8:55 AM
To Next Page
Loading...
