86 CHAPTER 5: SOFTWARE INSTALLATION AND CONFIGURATION UNDER WINDOWS 3.X
6 Select Configure NIC and press Enter.
The NIC Configuration screen is displayed.
Figure 59 NIC Configuration Screen
7 Select Auto Configure and press Enter.
The I/O base address, interrupt request level, and
transceiver type are automatically configured to settings
that do not conflict with other devices in your PC.
To change settings, follow the steps in “Changing
Configuration Settings” later in this chapter.
If you encounter a problem with the Auto Configure
option, press F1 for help.
The OK button is selected when configuration
is completed.
8 Press Enter to accept the configuration parameters.
The NIC is now configured.
Book Page 86 Monday, June 7, 1999 8:55 AM
To Next Page
Loading...
