3Com 3C509B - Using the 3 Com Installation Wizard for Windows 95;98; Required Information for Custom Installation

3
USING THE 3COM
INSTALLATION WIZARD
FOR WINDOWS 95/98
This chapter describes how to install and configure
the 3C509B NIC under Windows 95/98 using the
3Com Installation Wizard Custom installation option.
If your PC is running Windows NT, go to Chapter
4. Wizard
installation is not available for Windows NT. If your PC is
running DOS, Windows 3.1, or Windows for Workgroups,
go to Chapter 5.
To install the NIC using the Express installation option,
see the Quick Guide for the EtherLink 10 Mbps ISA
Network Interface Card.
Required Information for Custom Installation
The following information may be required to complete
the Custom installation described in this chapter:
■ I/O base address (for non-Plug and Play PCs)
■ Available interrupt request (IRQ) level
■ TCP/IP configuration data:
■ IP address
■ Subnet mask
■ Gateway address
■ DNS address data:
■ Host address
■ Domain address
■ Server address
Consult with your network administrator to obtain the
required information before starting.
Book Page 47 Monday, June 7, 1999 8:55 AM