4
SOFTWARE INSTALLATION
AND CONFIGURATION
UNDER WINDOWS NT
This chapter describes how to load 3C509B NIC drivers
and configure the NIC for Windows NT 4.0. You can apply
the basic procedure described in this chapter to load drivers
for Windows NT 3.51. The driver load procedures for
Windows NT 4.0 and 3.51 are similar, with some variation
due to design differences in the Microsoft interface for
both versions.
If your PC is running Windows 95/98, go first to Chapter
2
and next to Chapter 3. If your PC is running DOS,
Windows 3.1, or Windows for Workgroups, go
to Chapter 5.
If you are installing multiple 3C509B NICs in a
Windows NT PC, follow the procedure in “Installing
Multiple NICs in a Windows NT PC” on page 78.
Installing Drivers and Configuring the NIC
Follow these steps to install and configure the 3C509B NIC
under Windows NT 4.0:
1 Install the NIC in your PC. (See Chapter 1.)
2 Boot Windows NT.
3 Double-click the My Computer Icon, double-click
the Control Panel icon, and then double-click the
Network icon.
The Network screen appears, as shown in Figur
e 46.
Book Page 69 Monday, June 7, 1999 8:55 AM
To Next Page
Loading...
