58 CHAPTER 3: USING THE 3COM INSTALLATION WIZARD FOR WINDOWS 95/98
To Specify a DNS Address Manually
Follow these steps to specify a DNS address manually:
1 Select the Specify DNS manually radio button if
you are using a permanent DNS address.
Figure 35 Specify a DNS Address Screen
If DNS has been previously configured on your PC,
the fields on this screen may already be filled in.
If DNS has not been previously configured on your
PC, these fields are blank and you must fill them in
to enable DNS.
2 Enter the host and domain data in their
respective fields.
3 To configure a new server, enter the new
server address, and then click Add New Server.
The new server appears in the Servers list box.
4 Click Test DNS Connection to verify that the
connection to the DNS server is functioning.
While the test is running, a progress bar indicates
test progress.
Book Page 58 Monday, June 7, 1999 8:55 AM
To Next Page
Loading...
