Windows 95/98 Setup 41
5 Select The updated driver (Recommended) and then
click Next.
Windows again requests that you verify that you want to
install the displayed driver, as shown in Figure 21.
Figure 21 Add New Hardware Wizard Screen (5)
6 Click Next.
Windows 98 copies the required files to your hard disk
and builds the driver information database.
The 3Com Installation Wizard starts. Go to Chapter 3.
Disabling Plug and Play on the NIC
If your Windows 95/98 PC does not support Plug and Play,
you must disable Plug and Play on the NIC before you can
install the NIC software.
Follow these steps to disable Plug and Play on the NIC:
1 After installing the NIC in the PC, turn the power on
and boot Windows 95/98.
2 Insert EtherDisk diskette 2 in drive A.
Book Page 41 Monday, June 7, 1999 8:55 AM
To Next Page
Loading...
