42 CHAPTER 2: CUSTOM INSTALLATION SETUP FOR WINDOWS 95/98
3 Click Start in the Windows 95/98 taskbar, and then
click Run.
4 Enter:
a:\pnpdsabl.bat
DOS PNPDSABL generates the messages shown in
Figure 22. Plug and Play is disabled on the NIC.
Figure 22 DOS PNPDSABL Screen for Windows 95
5 If you are running Windows 95, click the X in
the upper right corner of the screen to close the
DOS screen. If you are running Windows 98, enter
exit to return to Windows 98.
6 Remove the diskette from drive A.
7 Shut down the PC and turn the power off, then on.
The NIC is not detected when the PC reboots.
The next step is to configure the NIC.
Book Page 42 Monday, June 7, 1999 8:55 AM
To Next Page
Loading...
