34 CHAPTER 2: CUSTOM INSTALLATION SETUP FOR WINDOWS 95/98
5 Type in names for the PC and its workgroup according
to the following guidelines:
:
6 Click Close.
The 3Com Installation Wizard starts. Go to Chapter 3.
Configuring the NIC for Windows 95, Version 950b
Follow these steps to configure the NIC in a PC that
has a Plug and Play BIOS installed, and that is running
Windows 95 version 950b (also known as version B,
OSR2, or the “OEM” version):
1 Turn the power on and boot Windows 95.
The New Hardware Found screen appears. Then the
Update Device Driver Wizard screen is displayed, as
shown in Figure 13.
Computer name Identifies the computer on the network for
other users. This entry must be a unique
name of 15 characters or fewer, containing
no spaces.
Workgroup Identifies the group to which your
computer belongs. If you are setting up
a simple peer-to-peer network, this entry
must be the same for all the PCs in
your network.
Computer
Description
Displays additional details to other users
on the network about this PC. Filling this
field is optional.
Book Page 34 Monday, June 7, 1999 8:55 AM
To Next Page
Loading...
