76 CHAPTER 4: SOFTWARE INSTALLATION AND CONFIGURATION UNDER WINDOWS NT
Figure 54 Microsoft TCP/IP Dialog Box
b Click Yes.
The Network Settings Change dialog box appears,
prompting you to restart Windows NT.
Figure 55 Network Settings Change Dialog Box (1)
c Click Yes to restart Windows NT.
TCP/IP is installed and configured.
■ To specify an IP address manually — Follow these
steps to install and configure TCP/IP manually:
a Verify that the Specify an IP address radio button is
selected, as shown in Figure 52.
b Enter the IP address, subnet mask address, and default
gateway address in their respective entry fields, as
shown in Figure 56.
Book Page 76 Monday, June 7, 1999 8:55 AM
To Next Page
Loading...
