48 CHAPTER 3: USING THE 3COM INSTALLATION WIZARD FOR WINDOWS 95/98
Custom Installation
In the last step of the Windows 95 or Windows 98
setup procedure in Chapter 2, clicking Next starts the
3Com Installation Wizard.
The first 3Com Installation Wizard screen appears.
Figure 27 Selecting Custom Installation Screen
Follow these steps to perform a Custom installation:
1 Select the Custom Installation radio button, shown
in Figure 27.
Selecting Skip Installation at step 1 completely bypasses the
Wizard installation. The drivers for the NIC will be loaded,
but you may have to complete the NIC configuration
by using the procedures documented in Chapter 6,
“Troubleshooting for Windows 95/98 and Windows NT.”
After selecting Skip Installation, go to “Completing the
Installation and Configuration” on page 63.
For Express Installation, see instructions in the Quick Guide
for the EtherLink 10 Mbps ISA Network Interface Card.
2 Click Next.
The NIC Configuration Settings screen appears, as
shown in Figur
e 28.
Book Page 48 Monday, June 7, 1999 8:55 AM
To Next Page
Loading...
