Changing Configuration Settings 91
If you are using a PC that supports Plug and Play, the IRQ
and I/O base address values are set by Plug and Play. You
can set the boot PROM size to indicate the presence and
size of a network boot PROM. For instructions on disabling
Plug and Play, see “Disabling Plug and Play on the NIC” on
page 41.
Follow these steps to change the configuration settings:
1 Run the installation program described in
“Configuring the NIC” on page 85.
2 From the main menu (see Figure 58 on page 82),
select Configuration and Diagnostic Program.
3 If multiple NICs are installed in the PC, use the arrow
keys to select the NIC you want to configure. Press
Tab to move to the Select button and press Enter.
4 Press Tab to display the dialog box, and then select
the option that you want to change. Press Enter.
5 Use the arrow keys to scroll through the list of
settings for that option. Select a setting and
press Enter.
6 Continue this procedure for other options. For more
information on a specific option, select the option
and press F1.
7 To save the new settings, select OK and press Enter.
Book Page 91 Monday, June 7, 1999 8:55 AM
To Next Page
Loading...
