CHAPTER 11: CONFIGURING SPANNING TREE
141
Enabled —Specifies the Edge Port is enabled on the port.
Disabled —Specifies the Edge Port is disabled on the port.
No Change —Maintains the current the Edge Port settings. This
is the default value.
Link Type — Specifies the RSTP link type. The possible field values
are:
Point to Point —Enables the device to establish a Point-to-Point
link on the port. Ports set to Full Duplex modes are considered
Point-to-Point port links.
Shared — Enables the device to establish a shared link on the
port.
Auto — Enables the device to establish automatically a Point-to
Point link.
Path Cost — Indicates the port contribution to the root path cost.
The path cost is adjusted to a higher or lower value, and is
used to forward traffic when a path is re-routed. The field range is
1-200,000,000.
Priority — Priority value of the port. The priority value influences
the port choice when a bridge has two ports connected in a loop
The priority value is between 0 -240.
Select Port(s) — Indicates the ports to be defined.
Select All — Allows the user to assign the STP settings to all
ports.
Select None — Removes the ports selected.
2 Select the ports to be defined
3 Define the fields.
4 Click Apply. Spanning Tree is modified on the port, and the device
is updated.
To Next Page
Loading...
