238 CHAPTER 16: IP ROUTING PROTOCOL OPERATION
■ Setting the Interface Priority for DR Election
■ Configuring the Peer
■ Setting the Interval of Hello Packet Transmission
■ Setting a Dead Timer for the Neighboring Routers
■ Configuring an Interval Required for Sending LSU Packets
■ Setting an Interval for LSA Retransmission between Neighboring Routers
■ Setting a Shortest Path First (SPF) Calculation Interval for OSPF
■ Configuring STUB Area of OSPF
■ Configuring the NSSA of OSPF
■ Configuring the Route Summarization of OSPF Area
■ Configuring Summarization of Imported Routes by OSPF
■ Configuring OSPF Virtual Link
■ Configuring the OSPF Area to Support Packet Authentication
■ Configuring OSPF Packet Authentication
■ Configuring OSPF to Import Routes of Other Protocols
■ Configuring Parameters for OSPF to Import External routes
■ Configuring OSPF to Import the Default Route
■ Setting OSPF Route Preference
■ Configuring OSPF Route Filtering
■ Configuring the Filling of the MTU Field When an Interface Transmits DD Packets
■ Disabling the Interface to Send OSPF Packets
■ Configuring OSPF and Network Management System (NMS)
■ Resetting the OSPF Process
Enabling OSPF and Entering OSPF View
Perform the following configurations in System View.
By default, OSPF is not enabled.
When enabling OSPF, note the following:
■ By default, the OSPF process ID is 1.
■ If a router is running multiple OSPF processes, 3Com recommends that you to use
router-id in the command to specify different Router IDs for different processes.
Table 221 Enabling the OSPF process
Operation Command
Enable the OSPF process ospf [ process_id [ router-id router_id ] ]
Disable the OSPF process undo ospf [ process_id ]
To Next Page
