EasyManua.ls Logo

3Com 5500-SI - Configure NTP Broadcast Mode

3Com 5500-SI
686 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
502 CHAPTER 22: FILE SYSTEM MANAGEMENT
3 Configure Switch 5: (Switch 4 has been synchronized by Switch 3)
a Enter System View.
<switch5> system-view
b After performing local synchronization, set Switch 4 as a peer.
[switch5]ntp-service unicast-peer 3.0.1.32
The above examples configure Switch 4 and Switch 5 as peers and configures Switch
5 in active peer mode and Switch 4 in passive peer mode. Since Switch 5 is at stratum
1 and Switch 4 is at stratum 3, synchronize Switch 4 by Switch 5.
After synchronization, Switch 4 status is shown as follows:
[switch4]display ntp-service status
clock status: synchronized
clock stratum: 8
reference clock ID: 3.0.1.31
nominal frequency: 100.0000 Hz
actual frequency: 100.0000 Hz
clock precision: 2^17
clock offset: 0.0000 ms
root delay: 0.00 ms
root dispersion: 10.94 ms
peer dispersion: 10.00 ms
reference time: 20:54:25.156 UTC Mar 7 2002(C0325201.2811A112)
By this time, Switch 4 has been synchronized by Switch 5 and it is at stratum 2, or
higher than Switch 5 by 1.
Display the sessions of Switch 4 and you will see Switch 4 has been connected with
Switch 5.
[switch4]display ntp-service sessions
source reference stra reach poll now offset delay disper
*******************************************************************
[12345]127.127.1.0 LOCAL(0) 7 377 64 57 0.0 0.0 1.0
[5]1.0.1.11 0.0.0.0 16 0 64 - 0.0 0.0 0.0
[5]128.108.22.44 0.0.0.0 16 0 64 - 0.0 0.0 0.0
note: 1 source(master),2 source(peer),3 selected,4 candidate,5
configured
Configure NTP Broadcast
Mode
Network Requirements
On Switch 3, set local clock as the NTP master clock at stratum 2 and configure to
broadcast packets from Vlan-interface2. Configure Switch 4 and Switch 1 to listen to
the broadcast from their Vlan-interface2 respectively. (Note that Switch 3 must
support setting local clock as the NTP master clock.)
Networking Diagram
See Figure 132.
Configuration Procedure
1 Configure Switch 3:
a Enter System View.
<switch3> system-view
b Set the local clock as the NTP master clock at stratum 2.
[switch3]ntp-service refclock-master 2

Table of Contents

Other manuals for 3Com 5500-SI

Related product manuals