3Com 5500-SI - Management Device Configuration; Enabling System and Port NDP; Configuring NDP Parameters; Enabling System and Port NTDP

Management Device Configuration 605
Management Device
Configuration
Management device configuration involves:
■ Enable system and port NDP
■ Configure NDP parameters
■ Enable system and port NTDP
■ Configure NTDP parameters
■ Enable the cluster function
■ Configure cluster parameters
■ Configuring internal-external interaction
■ NM Interface for Cluster Management Configuration
Enabling System and
Port NDP
Configuring NDP
Parameters
Enabling System and
Port NTDP
Configuring NTDP
Parameters
Table 656 Enable system and port NDP
Operation Command Remark
Enter system view system-view —
Enable system NDP ndp enable Required
Enable port NDP ndp enable interface port-list Optional
Enter the Ethernet port interface interface-type interface-number —
Enable port NDP ndp enable Required
Table 657 Configure NDP parameters
Operation Command Remark
Enter system view system-view —
Configure holdtime of
NDP information
ndp timer aging
aging-in-seconds
Argument aging-in-seconds is the
holdtime of NDP information.
Configure interval of NDP
packets
ndp timer hello seconds Argument Seconds is the interval of
NDP packets.
Table 658 Enable system and port NTDP
Operation Command Remark
Enter system view system-view —
Enable system NTDP ntdp enable Required
Enter the Ethernet port interface interface-type
interface-number
—
Enable port NTDP ntdp enable Required
Table 659 Configure NTDP parameters
Operation Command Remark
Enter system view system-view —
Configure the topology
collection range
ntdp hop hop-value Optional
Argument hop-value is the hop range.