610 CHAPTER 32: CLUSTERING
Clustering
Configuration
Example
Network requirements
Three switches form a cluster, in which:
■ Switch 5500 acts as the management device.
■ Other two switches act as member devices.
As the management device, Switch 5500 manages the member devices and is
configured as follows:
■ It attaches two member devices through ports Ethernet1/0/2 and Ethernet1/0/3
respectively.
■ It connects with the external network through port Ethernet1/0/1.
■ Ethernet1/0/1 belongs to VLAN2, whose interface IP address is 163.172.55.1.
■ The same FTP server and TFTP server is used through the cluster.
■ The IP address of the FTP server and TFTP server is 63.172.55.1.
■ The IP address of the SNMP site and logging host is 69.172.55.4.
Network diagram
Cluster Management
Configuration procedure
1 Configure the management device
a Enable system NDP and port NDP on E1/0/2 and E1/0/3.
[S5500] ndp enable
[S5500] interface ethernet 1/0/2
[S5500-Ethernet1/0/2] ndp enable
[S5500-Ethernet1/0/2] interface ethernet 1/0/3
[S5500-Ethernet1/0/3] ndp enable
Management
device
Member device MAC address
00e0.fc01.0011
SNMP host/logging host
Cluster
Network
FTP server/TFTP server
E1/0/ 3
E1/0/2
E1/1 E1/1
E1/0/1
69.172.55.4
63.172.55.1
VLAN2 interface IP address
163.172.55.1
Member device MAC address
00e0.fc01.0012
Management
device
Member device MAC address
00e0.fc01.0011
SNMP host/logging host
Cluster
Network
FTP server/TFTP server
E1/0/ 3
E1/0/2
E1/1 E1/1
E1/0/1
69.172.55.4
63.172.55.1
VLAN2 interface IP address
163.172.55.1
Member device MAC address
00e0.fc01.0012
To Next Page
Loading...
