3Com AP9552 Hardware Installation Guide

112
Appendix B Regulatory Information
General Statements
The 3Com AP9552 Dual Band 802.11n PoE Access Point (3CRWE955275; M/N:
WL-605) must be installed and used in strict accordance with the manufacturer’s
instructions as described in the user documentation that comes with the product.
This product contains encryption. It is unlawful to export out of the U.S. without
obtaining a U.S. Export License.
This product does not contain any user serviceable components. Any unauthorized
product changes or modifications will invalidate 3Com’s warranty and all applicable
regulatory certifications and approvals.
Only antennas specified for your region by 3Com can be used with this product. The
use of external amplifiers or non-3Com antennas may invalidate regulatory
certifications and approvals. This product can be used with the following antennas and
accessories:
Item Description Exclusions
Internal antenna None
3CWE590 Rubber Duck Antenna None
3CWE591
3Com 6/8dBi Dual-Band
Omni Antenna
Must be used with 3CWE586 and one of the
following: 3CWE580,3CWE581 or 3CWE582.
3CWE596
18/20dBi Dual-Band
Panel Antenna
Must be used with 3CWE586 and one of the
following: 3CWE580,3CWE581 or 3CWE582.
3CWE598
8/10dBi Dual-Band
Panel Antenna Product
Must be used with 3CWE586 and one of the
following: 3CWE580,3CWE581 or 3CWE582.
3CWE580
3Com Ultra Low Loss
6-Foot Antenna Cable
Must also use 3CWE586.
3CWE581
3Com Ultra Low Loss
20-Foot Antenna Cable
Must also use 3CWE586.
3CWE582
3Com Ultra Low Loss
50-Foot Antenna Cable
Must also use 3CWE586.
3CWE586
3Com RSMA to SMA 6-
inch Antenna Cable
Required for all external antennas
(not required for Internal antenna and
Rubber Duck Antenna).
Caution: Exposure to Radio Frequency Radiation
z This device generates and radiates radio-frequency energy. In order to comply
with FCC radio-frequency exposure guidelines for an uncontrolled environment,
this equipment must be installed and operated while maintaining a minimum
body to antenna distance of 20 cm (approximately 8 in.).

3Com AP9552 Specifications

General

Model	AP9552
Device Type	Wireless Access Point
Frequency Bands	2.4 GHz, 5 GHz
Power over Ethernet	Yes
Antenna Type	Internal
Wireless Standard	IEEE 802.11a/b/g
Data Link Protocol	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g
Ethernet Ports	1 x 10/100
Encryption Algorithm	WEP, WPA, WPA2
Authentication Method	RADIUS
Compliant Standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g
Operating Temperature	32 °F to 104 °F (0 °C to 40 °C)
Power Supply	Power over Ethernet (PoE)