6
2) To lock the stand to the AP, slide the stand back and the AP forward, as
shown here:
3) Place the AP and table stand on the table.
4) Connect the Ethernet cable for power and network connection to the LAN port
on the back of the AP.
Ceiling Mounting
To install your AP on the ceiling, use the ceiling bracket kit that comes with the device.
Follow these steps:
1) Attach the metal slider to the back of the AP using the two small screws. The
slider should still be able to slide after the screws are tightened, Make sure
that the slide is left in the same position as shown below so that the slots are
accessible.
To Next Page
Loading...
Need help?
General
