Name: 3D Systems ProJet 360
Brand: 3D Systems
Rating: 5 (1 reviews)

To Next Page

To Previous Page

ProJet

x60 Series User Guide Routine Cleaning

5/12/13

4. Position the squirt bottle close to the station and squirt water into the service station.

5. Use the cotton swabs or a paper towel and wipe the service station thoroughly.

6. Use a brush or the Pick to scrape excess Core out of any corners.

7. Thoroughly wipe the Service Station clean.

8. Wipe up any water that may have spilled onto the Deck or Build Bed. Vacuum up any loose Core. Do

not vacuum the service station itself.

Important: Never vacuum up water or other fluids - it will clog the vacuum system.

9. Remove the paper towels from the front overflow. Close the printer top cover.

Questions and Answers:

Need help?

Do you have a question about the 3D Systems ProJet 360 and is the answer not in the manual?

3D Systems ProJet 360 Specifications

General