EasyManuals Logo

3D Systems ProJet 360 User Manual

3D Systems ProJet 360
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #51 background imageLoading...
Page #51 background image
ProJet
®
x60 Series User Guide Printer Maintenance
3dscentral.3dsystems.com 45 All Rights Reserved
5/12/13
6.5 Clean The Spreader Roller
Frequency: On a regular schedule, depending on your usage. Or, whenever the printer has problems
related to the surface finish of horizontal surfaces.
1. On the LCD, select
BUILD CHAMBER then LOWER PLATFORM. Lower the build bed by 4-5 inches.
2. Move the Fast Axis out over the build bed.
3. On the LCD, select
BUILD CHAMBER then CONTROL ROLLER.
4. On the LCD, select
ROLLER ON/OFF to turn the Spreader Roller on.
5. Using a paper towel dampened with distilled water, clean the Spreader Roller thoroughly by reaching
up from underneath.
6. Dry the roller thoroughly with a clean dry paper towel.
7. On the LCD, select
ROLLER ON/OFF to turn the Spreader Roller off.
8. When finished, select
EXIT (ROLLER OFF) to return to the Main Menu.
9. Make sure the roller is completely dry before attempting to spread any Core.
Number Component
1 Spreader Roller

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the 3D Systems ProJet 360 and is the answer not in the manual?

3D Systems ProJet 360 Specifications

General IconGeneral
Layer Thickness0.1 mm
MaterialPhotopolymer resin
Resolution600 x 600 dpi
Build Volume298 x 185 x 203 mm
Power Requirements100-240 VAC, 50/60 Hz
Operating Temperature18-28°C

Related product manuals