EasyManuals Logo

3D Systems ProJet 360 User Manual

3D Systems ProJet 360
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
ProJet
®
x60 Series User Guide Troubleshooting the ProJet x60 Printers
3dscentral.3dsystems.com 47 All Rights Reserved
5/12/13
7 Troubleshooting the ProJet x60 Printers
If you should encounter any problems with your ProJet x60, the steps below will help you troubleshoot the
problem and, in most cases, correct it yourself. If you need to call service, we’ve provided a list of the infor-
mation to have ready for your Service Provider.
Start Here
Start with Section 7.1, ’Try This First’. In many cases this will solve the problem. If it doesn’t, gather the
information described below and use the Troubleshoot section that follows to find the problem.
Gather Information
Carefully observe what the printer is doing.
Turn the printer off, wait 1 minute, then turn it on again.
Does it power up normally? What is displayed on the LCD?
Does it report any errors? What are the error codes?
Are there problems with the parts it builds? What specifically is wrong with the parts?
Troubleshoot
Once you have the information above, use these troubleshooting flowcharts and tables to isolate the prob-
lem.
Power Up Problems
Section 7.2, ’Problems Powering Up’
Print Head Errors
Section 7.3, ’Print Head Errors/Weak Parts’
Motion Errors
Section 7.4, ’Motion Errors/Fast Axis
Section 7.5, ’Motion Errors/Slow Axis’
Network Errors
Section 7.6, ’Network Errors/Cannot Connect to Printer
Section 7.7, ’Network Errors/Packet Timeout
Part Quality Problems
Section 7.8, ’Part Quality Issues Streaky/Striped Parts, Delamination, Weak Parts’
Section 7.9, ’Part Quality Issues Bad Surface Finish’
Other problems
Section 7.10, ’Miscellaneous Problems’
Additional information
Section 7.11, ’Error Codes and Messages Background Details’
Section 7.12, ’Additional Information’
Call for Service
If you do need to call service, use the checklist provided here to gather the information your Service Pro-
vider will need.
Section 7.13, ’Calling for Service’

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the 3D Systems ProJet 360 and is the answer not in the manual?

3D Systems ProJet 360 Specifications

General IconGeneral
Brand3D Systems
ModelProJet 360
CategoryPrinter
LanguageEnglish

Related product manuals