Need help?Do you have a question about the 3DGence DOUBLE P255 and is the answer not in the manual?
General| Brand | 3DGence |
|---|---|
| Model | DOUBLE P255 |
| Category | 3D Printers |
| Language | English |
Lists general safety precautions for printer installation and operation.
Outlines the electrical characteristics and connection requirements for the printer.
Lists essential checks to perform before starting the printer.
Step-by-step guide for updating the printer's firmware.
Instructions for unpacking and performing the initial setup of the printer.
Details on heatbed preparation and the automatic calibration process.
Step-by-step guide for loading filament into the printer.
Instructions for safely unloading filament from the printer.
Addresses common issues and solutions for material loading and unloading.
Explains how to change filament while a print job is in progress.
Guide to initiating a print job using an SD card.
Explains the process for changing the printer's hotends.
When to calibrate heatbed and how to change the ceramic surface.
Introduction to calibrating the dual hotend module's axes.
Steps for precise axes calibration, including measurements.
Explains calibration of hotend offsets along X, Y, and Z axes.
Details common system error codes (E201-E205) and their resolution.
To Next Page
