2. SET OF PRINTER'S ACCESSORIES
3DGence DOUBLE P255 printer is delivered together with the set of consumables and the set of necessary accessories and
enclosure. The box includes:
• 3DGence DOUBLE P255 printer,
• SD memory card,
• power lead,
• USB cable,
• two bowden tubes,
• two spool holders,
• Dimafix adhesive stick,
• additional accessories,
• PLA filament spool,
• BVOH filament spool.
3. USER INTERFACE
3DGence DOUBLE P255 printer is equipped with a 4.3-inch colour touch screen located on the right side of the printer's front
panel (fig. 8, point 11). This is the printer's communication interface with a transparent graphic menu. The user menu structure
changes depending on the printer working status.
The menu architecture diagram is shown in chapter II, point 3.3.
3.1. Idle state menu
After connecting the printer to power supply and starting it, the start screen is displayed to indicate that the printer is preparing
for operation (fig. 16).
Fig. 16 Start screen
Then, the display shows the printer's main menu in idle state (fig. 17).
To Next Page
Loading...
