8
Figure 2.3.2.1: Poweri
1 Slide to connect
2 Hold to power
ng Solo
2.4 Controller
The Solo Controller includes a pre-installed rechargeable lithium ion (Li-ion) battery.
2.4.1 Charging
Charge the controller using the designated controller charger only; using a different charger can damage the
controller or cause a fire.
To charge the controller, connect the controller charger to the barrel jack on the side of the controller and to a
wall outlet. To check the battery level of the controller, press the power button. A fully charged controller lasts for
approximately 6 hours. Always check the controller’s battery level before you fly, and recharge when prompted by
the controller. The controller takes approximately three hours to charge to 100%.
Figure 2.4.1.1: Controller Charging
To Next Page
Loading...
