Need help?Do you have a question about the 3M MS2 and is the answer not in the manual?
General| Brand | 3M |
|---|---|
| Model | MS2 |
| Category | Power Tool |
| Language | English |
Instructions for performing inline splicing on a 2-bank configuration, including opening and setup.
Detailed steps for executing foldback splicing procedures on two-bank cable configurations.
Steps for performing unilength splicing, focusing on the use of 4005-DPM Super-Mate modules.
Procedure for half-tapping cables using the 4008 Half Tap Module.
Splice used when circuits cannot be multiplied due to bridge tap or engineering restrictions.
To Next Page
