4
3.0 Tool Description
3.1 Main Splicing Rig Components
The 4041 Splicing Head is used with a support
rig for:
• Initial termination of conductors in the
modules.
• Making connections with preterminated
modules.
3.1.1 The splice head allows you to arrange and hold
conductors in their proper locations during the
splicing procedure. The splice head will hold
the following module combinations:
• 1 Super-Mini and 1 Super Mate
• 2 Super Mates
• 3 Super Mates
4041 Splicing Head Double Head Set Up
3.1.3 The support tube and related components provide support for cables and tools while splicing is being done.
Support Tube
76683
832594
843047
791330
Crimping Clamp
4030 / Air Crimping Unit
4031 / Hand Hydraulic
Crimping Unit
893736
3.1.2 Air hydraulic and hand hydraulic crimping units are used with the 4041 Splice Head to crimp modules.
A mechanical crimper is also available to crimp modules.
Leaf Spring (2)
Wire
Retainer Screw
Pedestal
Detent
Pin Pocket
(Crimping Clamp)
Pair Separators
Color Coded
Wire Guides
Wire Retainer Spring (2)
Wire Retainer Size Plate
Connector Plate
Tape Plate
Allen Head Screws
Allen Head Screws
75495
Traverse Clamp
Buckle
Strap
Latch
Traverse Bar
Head Clamp
To Next Page
Loading...
Need help?
General
