7
3.3 Hand Tools - 4255 Hand Presser
Used for crimping covers or
bases on 4000-D Super-Mini
Modules or for plugging com-
binations of two modules
together.
• Base, Body, Cover
• Male to Female (precon)
• Super-Mini to Super-Mate
• Super-Mate to Super-Mate
822380
3.3.1 Hand Tools - 4270-A Series Hand Presser
Used for plugging a combinations of from two
through seven modules together.
893724
4270-A Hand Presser
4.0 Accessories
4.1 4075-S Super-Mini Sealant Boxes with
Insertion Tool
Designed for moisture protection and reentry
applications. The boxes can be applied to both
foldback and inline splices. The 4075-S is
designed to be used in all 2-wire 4000-D Super-
Mini splice applications.
4.2 4077 Series Sealant Boxes with Insertion Tool
The 4077 Series
Sealant Box is
designed for use
with the 4005-DPM
module.
• 4077-A - One Super-Mate Module
• 4077-B - One Super-Mate / One Super-
Mini Module
• 4077-C - Two Super-Mate Modules
• 4077-D - Three Super-Mate Modules
75516
873600
4.3 4051 Wire Insertion and Cut Off Tool
Individual conductors can be inserted into ele-
ments by using the 4051 Wire Insertion and Cut
Off Tool.
781181
781247
4.4 4078-C Half Tap Cover
Used to protect wire ends after the half-taps has
been cut out of the Super-Mini 4008 Half Tap
Module in pulp/paper and pressurized PIC cable
splices and vault splices.
832569
863423
4.7 4027 Pair Test Plug
The MS
2
4047 Pair Test
Plug is a connector probe
which permits pair checking
through the test entry port
without damaging wire insulation.
4.5 4053-PM Separator Tool
a. The 4053-PM is the only tool recommended
for unplugging Super-Mate Modules.
863422
b. The enlarged pins of the tool distinguish
the 4053-PM from the 4053 Cover Removal
Tool. The 4053-PM tool cannot be used to
remove covers or bases.
4.6 4047 Super-Mini Reentry Maintenance Kit
This kit is designed for maintenance and repair
work on Super-Mini Modules.
781184
To Next Page
Loading...
Need help?
General
