Installing MX-ONE
Figure 72 Connecting the Batteries in a 230 V System
General battery connection:
1 Connect the cable lug (L) of the grey cable supplied with the batteries
mounting set (BKB 201 003/1) to the red plus pole (D) of the rightmost
battery block, see Page 91 or Page 92.
2 Fasten the screw (B) to secure the cable lug and press down the cover
(I) on the red plus pole (D).
3 Connect the grey positive (+0V) DC supply cable (L) to the positive bus
bar/connector by inserting the stripped end to the hole of the screw
connector (X) so that the cable is behind the bus bar, and then tightening
the screw, see Page 91 or Page 92.
4 Connect the cable lug (M) of the black cable to the minus pole (D) of the
leftmost battery block, see Page 91 or Page 92.
92
6/1531-ASP 113 01 Uen J2 2008-07-17
To Next Page
Loading...