22
Call Forwarding “After Delay”
For internal and external calls
On:
H*61* (external access code, e.g. 0) Z (destination no.) * Z (period of
time in seconds, e. g.
20) #
Off:
H#61#
Only for internal calls
On:
H*611* (external access code, e.g. 0) Z (destination no.) * Z (period
of time in seconds, e. g.
20) #
Off:
H#611#
Only for external calls
On:
H*612* (external access code, e.g. 0) Z (destination no.) * Z (period
of time in seconds, e. g.
20) #
Off:
H#612#
Calls (only internal, only external or both types) are signalled at the selected terminal
and after the specified period of time, these calls are forwarded to another specified
terminal.
Call Forwarding for Other Users
In order to program call forwarding for call numbers of other users, you must have the
“Call forwarding for other user” authorisation. Also, you can only configure call for-
warding only for those users whose terminal have not been blocked for this type of
access (these users will themselves have the authorisation “Prevent call forwarding by
other user”). Please consult your system administrator if you have questions regarding
these authorisations.
Call forwarding for call numbers of other users always apply for internal and external
calls.
Immediately
On:
H*214* Z (user’s internal call no.) *Z (destination no.) #
Off: H#214* Z (user’s internal call no.) #
Calls for the user will immediately be forwarded to the other terminal. When the user
pick ups their headset they hear the special dialling tone.
To Next Page
Loading...
Need help?
General
