38
Least Cost Routing (LCR) is used for remote-controlled dialling, provided your system
administrator has correspondingly configured LCR and the LCR application in the
OpenCom 100 / Aastra 800. Ask him for the setting which applies to you.
Remote-Programmable Call Forwarding
Configuring the function
Z (reserved call no.)
Wait until the connection to the communications system has been established. You
hear a positive acknowledgement tone.
Z (system PIN) *
Z
(your internal call no.) * (external access code, e.g. 0)
Z (destination no.) #
Deleting the function
Z (reserved tel. no.)
Wait until the connection to the communications system has been established. You
hear a positive acknowledgement tone.
Z (system PIN) *
Z
(your internal tel. no.) #
Using the call number reserved in the OpenCom 100 / Aastra 800 for remote control,
you can configure or delete immediate call forwarding for your own call number from
a remote location. This remotely-programmed forwarding overwrites any other inter-
nally active forwarding. Forwarding “On Busy” and “After Delay” are not affected.
Incorrect or non-existent call numbers are rejected. Your authorisation is checked in
the same way as for forwarding within the OpenCom 100 / Aastra 800. A correct entry
is confirmed with a positive acknowledgement signal, and the external call subse-
quently ended.
Note
The procedure will be aborted if there is a pause of longer than 60 seconds between
the entry of two digits. Thanks to this time span, it is also possible to implement re-
mote-controlled functions from GSM cellphones.
To Next Page
Loading...
Need help?
General
