137
Car movement
To move the car, from position P press
the brake pedal and, select the desired
gear using the control panel (1) fig. 129
on the dashboard: D to move forwards
or R to engage reverse. The display will
show the gear engaged.
In "SCORPION TRACK" driving mode,
when the brake pedal is released,
the car starts moving forwards or
backwards ("creeping" effect). The
accelerator should not be pressed in
this case.
Automatic shift to P function
The function automatically put the
transmission in P (Park) if there is any
indication that the driver may leave
the car while the transmission is in D
(Drive), N (Neutral) or R (Reverse).
Operation with the ignition device
to the ENGINE position
The Auto Park function is activated
when the transmission is in position D
(Drive), N (Neutral) or R (Reverse) and
the following conditions are detected:
Seat belt not fastened
Brake pedal released
Accelerator pedal released
Driver's door open
Car speed is below 3 km/h.
Operation with the ignition device
to the STOP position
The Auto Park function is activated
when the transmission is in position
D (Drive), N (Neutral) or R (Reverse),
the car speed is less than 3 km/h and
the user requests the car to be turned
off by turning the ignition device to the
STOP position.
Gear engagement inhibition
This system prevents shifting the
transmission from position P (Park) or
N (Neutral) if the brake pedal has not
been previously pressed. With ignition
device in the ENGINE position:
the brake pedal must be pressed
in order to shift the transmission from
position P (Park) to positions R, N or D;
to shift the transmission from position
N (Neutral) to positions R or D the
brake pedal must be pressed.
Stopping the engine
The system automatically engages
P (Park) when the car is shut down
(ignition device in STOP position).
To stop the engine at speeds higher
than 2.5 km/h hold the button of the
ignition device pressed or press it three
times in a row within a few seconds.
The ignition device is in the ENGINE
position.
WARNING
129)
The brake servo is not active until the
engine is started, so you would need to
apply much more force than usual to the
brake pedal.
130)
Only engage a gear while keeping the
brake pedal fully pressed.
131)
The unexpected movement of the
car could injure the occupants or people
nearby. As a general rule, do not get out
of the car when it is in "READY" mode.
Before leaving the car, always apply the
parking brake, put the transmission in
the P (Park) position and turn the ignition
device to the STOP position. In this mode,
the transmission remains locked in position
P (Park), thus preventing any accidental
movement of the car.
132)
When you get out of the car, always
turn the ignition device to the STOP
position and lock all the doors.
133)
NEVER leave children unattended
inside the car, let alone leave the car with
the doors unlocked in a place that children
can access easily. Children may seriously,
or even fatally, injure themselves. Also
ensure that children do not inadvertently
operate the electric parking brake, the
brake pedal or the transmission button.
134)
Do not leave the electronic key inside
or near the car (or in a place accessible to
children). A child could activate the electric
window winders, other controls or even
start the car.
135)
Never use position P (Park) instead of
the electric parking brake. Always engage
the electric parking brake when parking the
To Next Page
Loading...
