199
190 F0S1313
remove the lens assembly and
replace the press-fit bulb (A) fig. 190,
making sure that it locks correctly.
Boot light
(where provided)
To replace the bulb, proceed as
follows:
open the boot;
using the screwdriver provided, pull
out the ceiling light (A) fig. 191;
191 AB0A0540
open the protection (B) fig. 192
replace the snap-fitted bulb;
192 AB0A0541
close the cover (B) on the lens;
then refit the ceiling light by inserting
it correctly in its housing, on one side
and then pressing on the other side
until it clicks into place.
WARNING
193)
Modifications or repairs to the electric
system that are not carried out properly
or do not take the system technical
specifications into account can cause
malfunctions leading to the risk of fire.
194)
Halogen bulbs contain pressurised
gas, in the case of breakage they may
burst causing glass fragments to be
projected outwards.
195)
Only replace the light bulbs when the
motor is off and in a position that does
not interfere with traffic and lets you safely
replace them (see the description in the
“When parked" chapter in the "Starting
and driving" section). Also ensure that the
motor is cold, to prevent the risk of burns.
IMPORTANT
73)
Halogen bulbs must be handled
holding the metallic part only. Touching
the transparent part of the bulb with your
fingers may reduce the intensity of the
emitted light and even reduce the lifespan
of the bulb. In the event of accidental
contact, wipe the bulb with a cloth
moistened with alcohol and let the bulb
dry.
74)
Where possible, it is advisable to
have bulbs changed at a Dealership. The
correct operation and direction of the
external lights are absolutely essential for
the safety of the car and of compliance
with the law.
To Next Page
Loading...
