205
Overpressure valve
209 F0S0839
If the tyre pressure is higher than
expected, after switching off the
compressor, it can be lowered by
means of the button, fig. 209, located
next to the black tube connection.
WARNING
198)
IMPORTANT: Do not exceed
80 km/h. Avoid sudden acceleration or
braking. The kit provides a temporary
repair, therefore the tyre must be
examined and repaired by a specialist
as soon as possible. Before using the
kit, ensure that the tyre isn't excessively
damaged and that the rim is in good
condition, otherwise do not use it and
call roadside assistance. Do not remove
foreign bodies from the tyre.
199)
Punctures on the sides of the tyre
may not be repaired. Do not use the
Fix&Go if the tyre was damaged as a result
of being used with the wheel underinflated.
200)
Wear the protective gloves provided
with the Fix&Go.
201)
Apply the adhesive label where it can
be easily seen by the driver as a reminder
that the tyre has been treated with the
Fix&Go. Drive carefully, particularly on
bends.
202)
Repairs are not possible in the case
of damage to the wheel rim (bad groove
distortion causing air loss). Do not remove
the foreign body (screws or nails) from the
tyre.
203)
As required by current regulations,
the information on chemical substances
for the protection of human health and the
environment and on the safe use of the
sealing fluid are on the packaging label.
Compliance with the indications on the
label is an essential condition to ensure
the safety and the effectiveness of the
product. Remember to carefully read the
label before use; the user of the product
is responsible for any damages caused
by improper use. The sealing fluid has an
expiration date. Replace the bottle if the
sealant has expired.
204)
The Fix&Go kit is not suitable for
definitive repairs, so the repaired tyres may
only be used temporarily. The Fix&Go kit
provides a temporary repair, therefore the
tyre must be examined and repaired by a
specialist as soon as possible.
205)
Alert other drivers that the car
is stationary in compliance with local
regulations: hazard warning lights, warning
triangle, etc. Any passengers on board
should leave the car, especially if it is
heavily laden. Passengers should stay
away from on-coming traffic while the
wheel is being changed. On hills or uneven
roads, use chocks or appropriate objects
to block the wheels of the vehicle.
206)
Never operate the compressor for
longer than 20 consecutive minutes: risk of
overheating.
207)
If the pressure falls below 1.8 bar, do
not drive any further: the Fix&Go cannot
guarantee proper seal because the tyre is
too damaged. Contact a Dealership.
208)
Carefully read the cartridge label
before use and avoid improper use. The kit
should be used by adults and cannot be
used by children.
209)
Do not let the compressor turned on
for longer than 10 consecutive minutes -
overheating hazard
210)
Use the kit only in case of a
punctured tyre.
IMPORTANT
76)
The sealant fluid is effective with
external temperatures from -40°C to
+50°C. The sealant fluid has an expiry date
and must be replaced periodically. It is
possible to repair tyres with damage on
the tread up to a maximum diameter of
6 mm. Show the cartridge and the label
to the personnel who will handle the tyre
treated with the Fix&Go.
77)
The surface of the tube may be hot.
IMPORTANT
6)
Dispose of the bottle and the sealant
liquid properly. Have them disposed of
in compliance with national and local
regulations.
To Next Page
Loading...
