IN AN EMERGENCY
204
206 F0S0836
activate the compressor setting the
ON-OFF button, fig. 206, to the on
position (button in position I)
when the pressure gauge indicates
the prescribed pressure indicated in
the "Wheels” chapter, "Technical Data”
section or on the label, switch the
compressor off by turning the button to
the OFF position (0)
207 F0S0837
If the pressure gauge fig. 207 indicates
a pressure lower than 2 bar / 29 psi 10
minutes after starting the compressor,
switch off the compressor, disconnect
the black tube of the compressor from
the tyre valve and undo the cartridge
from the compressor turning it by one
quarter of a turn anticlockwise and lift
it. Move the car by approximately 10
metres to allow the distribution of the
sealant.
Stop the engine, switch on the hazard
lights; stop the vehicle safely, apply the
parking brake; engage 1st gear if uphill
or reverse gear if downhill; wheels all
steered; on a steep gradient, place a
wedge or stone behind the wheels
and restore pressure using the black
compressor tube fig. 206 until the
prescribed pressure is reached.
If the pressure is still lower than 2 bar
/ 29 psi 10 minutes after turning on,
do not resume driving, but contact a
Dealership.
208 F0S0838
After driving approximately 8 km / 5
miles, place the vehicle in a safe and
easy area, stop the engine, switch on
the hazard lights, apply the parking
brake; engage 1st gear if uphill or
reverse gear if downhill with wheels all
steered. In the event of a steep slope,
place a wedge or stone behind the
wheels.
Take the compressor and restore the
pressure using the black inflation tube.
If the pressure shown is higher than 2
bar / 29 psi, restore the pressure and
carefully drive to a Dealership in the
shortest possible time. Otherwise, if
the pressure is less than 2 bar / 29 psi,
do not resume driving, but contact a
Dealership.
To Next Page
Loading...
