37
PARKING LIGHTS
With the ignition device turned to
STOP, turning the ring (B) from the
AUTO position to position will light
up the side/tail lights and number plate
lights. Warning light lights up on
the instrument panel.
If the side lights are left on and the
driver side door is opened, a buzzer
sounds and the display shows a
dedicated message warning the driver
that the car is being left with the lights
on. The buzzer stops when the driver
side door is closed.
REAR FOG LIGHT
With ignition device in the ENGINE
position, press button (C) fig. 37 to
switch the light on/off. The rear fog
light switches on only when the dipped
headlights are on. To switch off the
rear fog lights, press the button (C),
switch off the dipped beam headlights
or turn the ignition device to the STOP
position.
37 AB0A0517
With rear fog lights on, the warning
light on the instrument panel will come
on at the same time.
MAIN BEAM HEADLIGHTS
To activate the fixed main beam
headlights, with the ignition device in
the ENGINE position, push left lever
(A) fig. 36 towards the dashboard. The
ring (B) must be turned to AUTO with
the dipped beam headlights on, or it
should be turned to position . The
warning light on the instrument
panel switches on. The main beam
headlights are deactivated bringing
the lever back to the central stable
position. Warning light switches off
in the instrument panel.
AUTOMATIC MAIN BEAM
HEADLIGHTS
In order not to dazzle other road users,
the lights are automatically deactivated
when approaching cars travelling in the
opposite direction or when following a
car travelling in the same direction.
This function is enabled via the
Uconnect™ system (see "Settings" in
the"Vehicle mode" paragraph in the
"Multimedia" section).
Turn the light switch to the AUTO
position (B) fig. 36. The first time the
main beam headlights are activated
(pushing the left stalk towards the
dashboard), the function is activated
(warning light comes on in the
instrument panel).
If the main beam headlights are actually
on, the warning light will also come
on in the instrument panel).
When the speed is higher than 40 km/h
and the function is active, the lights
switch off if the lever is taken again to
the stable central position.
When the speed is lower than 15 km/h
and the function is active, the function
switches the main beam headlights off.
If the fixed main beam headlights are
operated quickly again (taking the lever
again to the stable central position and
taking it back in a few seconds on the
fixed main beam headlight position),
the warning light will switch on
in the instrument panel and the main
beam headlights will be switched on
constantly until the speed exceeds
40 km/h.
To Next Page
Loading...
