EasyManua.ls Logo

Abarth 500e - Page 63

Default Icon
314 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
KNOWING YOUR CAR
38
When the speed of 40 km/h is
exceeded again, the function is
activated automatically again.
If the lever is pulled again in this
condition, to request main beam
headlight deactivation, the function
remains off and the main beam
headlights switch off.
To deactivate the automatic function
rotate the light switch ring to position
.
FLASHING THE
HEADLIGHTS
Pull the left lever towards the steering
wheel, to the unstable position; when
released it returns automatically to
the stable, central position. With main
beam headlights on, the warning light
on the instrument panel will come
on at the same time.
DIRECTION INDICATORS
Take the left stalk to the (stable)
position:
upwards: activates the right
direction indicator;
downwards: activates the left
direction indicator.
Warning light or will blink
on the instrument panel. The
direction indicators are switched off
automatically when the steering wheel
is straightened.
"Lane Change" function
If you wish to signal a lane change,
place the left stalk in the unstable
position for less than half a second.
The direction indicator on the side
selected will be activated for 5 flashes
and then go out automatically.
COURTESY LIGHTS
The function can be enabled and
timed using the "Settings" menu of the
Uconnect system (see "Settings" in
the"Vehicle mode" paragraph in the
"Multimedia" section).
When the doors are unlocked, the
side/tail lights and puddle lights come
on for the time set in the menu.
Once any door is opened, the lights
remain on for a further 180 seconds, or
for a further 10 seconds after the door
is closed.
"FOLLOW ME HOME"
DEVICE
This allows the space in front of the car
to be lit for a set time.
Activation
With the ignition device turned to STOP
or removed, pull the stalk towards the
steering wheel within 2 minutes from
when the motor is turned off.
Each time the stalk is moved, the lights
stay on for an extra 30 seconds up to
a maximum of 210 seconds; then the
lights are switched off automatically.
Also, each time the stalk is operated,
the warning light on the
instrument panel switches on.
The warning light comes on
when the stalk is first moved and stays
on until the function is automatically
deactivated. Each movement of the
stalk only increases the amount of time
the lights stay on.
Deactivation
Hold the stalk pulled towards the
steering wheel for more than 2 seconds
or turn the ignition device to the
ENGINE position.
WELCOME LIGHT
(where provided)
Depending on the version, with the
ignition device in the STOP position,
an animated sequence of front lights
may can be shown when the doors
of the car are unlocked. Then they
light up fixed. To enable the function
set the courtesy lights in a state other
than OFF on the Uconnect system
(see "Settings" in the "Vehicle mode"
paragraph in the "Multimedia" section).
Only the direction indicators will light up
when only the tailgate is unlocked.
Activating the alarm or hazard lights will
disable the welcome light feature.

Table of Contents

Other manuals for Abarth 500e