ABB 2 Series - Stop a Charge Session

66 “Operation and installation manual” - “Terra 360 Series 2 - CE”
EN
8.3.2 Stop a charge session
• On the touchscreen, press the Stop button.
NOTE
When the battery is full, the charge session stops automatically.
Danger: Hazardous voltage
The connector is unlocked by the vehicle.
• If the touchscreen shows a message, do the instruction that the touchscreen shows.
• Disconnect the EV charge cable from the EV.
NOTE
In some cases, the EV locks the connector to the EV. To unlock the connector, obey the instructions
for the EV.
• Place EV charge cable back on the EVSE cable holder.
NOTE
Insert the cable into the cable holder located on the same side.