Technical data
150
Tightening torques for power connections
Screw size Torque
M5 3.5 Nm (2.6 lbf.ft)
M6 9 Nm (6.6 lbf.ft)
M8 20 Nm (14.8 lbf.ft)
M10 40 Nm (29.5 lbf.ft)
M12 70 Nm (52 lbf.ft)
M16 180 Nm (133 lbf.ft)
Applicable standards
The drive complies with the following standards. The compliance with the European Low
Voltage Directive is verified according to standards EN 61800-5-1 and EN 60204-1.
• EN 61800-5-1:2007 Adjustable speed electrical drives. Part 5-1: Safety requirements. Electrical, thermal and
energy.
• EN 60204-1:2006 +
A1:2009
Safety of machinery. Electrical equipment of machines. Part 1: General requirements.
Provisions for compliance: The final assembler of the machine is responsible for installing
- an emergency-stop device
- a supply disconnecting device
- the drive module into a cabinet.
• EN 60529:1991 (IEC 60529) Degrees of protection provided by enclosures (IP code)
• IEC 60664-1:2007 Insulation coordination for equipment within low-voltage systems. Part 1: Principles,
requirements and tests.
• EN 61800-3:2004 Adjustable speed electrical power drive systems. Part 3: EMC requirements and specific
test methods.
• UL 508C:2002, Third Edition UL Standard for Safety, Power Conversion Equipment
• CSA C22.2 No. 14-10 Industrial control equipment
To Next Page
Loading...
