Mechanical installation
55
Fastening the unit to the floor and wall (Marine units)
The unit must be fastened to the floor and roof (wall) as follows:
Use M10 or M12 screws; welding not
recommended (see section Electric
welding below).
1
2
1
2
3
Bolt the unit to the floor through the holes in
each flat bar at the base of the cabinet using
M10 or M12 screws.
If there is not enough room behind the cabinet
for installation, clamp the rear ends of the flat
bars as shown in figure (2).
Fasten the top of the cabinet to the rear wall
and/or roof using brackets with a rubber
damper in between.
Clamping the cabinet to the
floor at the back
Back panel of
cabinet
Flat bars at base of cabinet
Clamps
3
Fastening the cabinet at the top with
brackets (side view)
Cabinet
M16 bolt
L-bracket
To Next Page
Loading...
