ABB ACS850-04 - Page 112

112 Parameters
10.07 Jog1 start If enabled by parameter 10.09 Jog enable, selects the source
for the activation of jogging function 1. (Jogging function 1
can also be activated through fieldbus regardless of
parameter 10.09.)
1=Active.
See also other jogging function parameters: 10.08 Jog2 start,
10.09 Jog enable, 21.07 Speed ref jog1, 21.08 Speed ref
jog2, 22.10 Acc time jogging, 22.11 Dec time jogging and
19.07 Zero speed delay.
Note: This parameter cannot be changed while the drive is
running.
DI3 Digital input DI3 (as indicated by 02.01 DI status, bit 2). 1073873409
DI4 Digital input DI4 (as indicated by 02.01 DI status, bit 3). 1073938945
DI5 Digital input DI5 (as indicated by 02.01 DI status, bit 4). 1074004481
DI6 Digital input DI6 (as indicated by 02.01 DI status, bit 5). 1074070017
DIO4 Digital input/output DIO4 (as indicated by 02.03 DIO status,
bit 3).
1073938947
DIO5 Digital input/output DIO5 (as indicated by 02.03 DIO status,
bit 4).
1074004483
Const Bit pointer setting (see Terms and abbreviations on page 93). -
Pointer
10.08 Jog2 start If enabled by parameter 10.09 Jog enable, selects the source
for the activation of jogging function 2. (Jogging function 2
can also be activated through fieldbus regardless of
parameter 10.09.)
1=Active.
See also parameter 10.07 Jog1 start.
Note: This parameter cannot be changed while the drive is
running.
DI3 Digital input DI3 (as indicated by 02.01
DI status, bit 2). 1073873409
DI4 Digital input DI4 (as indicated by 02.01 DI status, bit 3). 1073938945
DI5 Digital input DI5 (as indicated by 02.01 DI status, bit 4). 1074004481
DI6 Digital input DI6 (as indicated by 02.01 DI status, bit 5). 1074070017
DIO4 Digital input/output DIO4 (as indicated by 02.03 DIO status,
bit 3).
1073938947
DIO5 Digital input/output DIO5 (as indicated by 02.03 DIO status,
bit 4).
1074004483
Const Bit pointer setting (see Terms and abbreviations on page 93). -
Pointer
10.09 Jog enable Selects the source for enabling parameters 10.07 Jog1 start
and 10.08 Jog2 start.
Note: Jogging can be enabled using this parameter only
when no start command from an external control location is
active. On the other hand, if jogging is already enabled, the
drive cannot be started from an external control location apart
from jog commands through fieldbus.
DI3 Digital input DI3 (as indicated by 02.01 DI status, bit 2). 1073873409
DI4 Digital input DI4 (as indicated by 02.01 DI status, bit 3). 1073938945
DI5 Digital input DI5 (as indicated by 02.01 DI status, bit 4). 1074004481
No. Name/Value Description FbEq