Safety instructions
7
WARNING! Ignoring the following instructions can cause physical injury or death, or
damage to the equipment.
•
Never attempt to repair a malfunctioning drive; contact your local ABB
representative or Authorized Service Center.
•
Make sure that dust from drilling does not enter the drive during the installation.
Electrically conductive dust inside the drive may cause damage or lead to
malfunction.
•
Ensure sufficient cooling.
WARNING! The printed circuit boards contain components sensitive to electrostatic
discharge. Wear a grounding wrist band when handling the boards. Do not touch
the boards unnecessarily.
To Next Page
Loading...
Need help?
General
